FIRST
set of valves for connecting radiators with internal thread G 1/2 ". Compact design that minimally extends into the bathroom space. Allows connection of water supply to the left or right side. The valves are fitted with plastic sealing rings for reliable and quick installation.

The set contains:
Radiator corner valve with control handle
Design: corner, for connection from the wall (not from the floor)
Inlet for connection to the pipeline: external thread 24x19 - it is necessary to purchase a compression seal for the copper or plastic pipeline
Radiator outlet: G 1/2 "special sealing ring for reliable and quick installation

- Material: brass
- Finish: chrome
- Control handle: ABS plastic, chrome

Reverse throttle valve
Design: corner, for connection from the wall (not from the floor)
Inlet for connection to the pipeline: external thread 24x19 - it is necessary to purchase a compression seal for the copper or plastic pipeline
Radiator outlet: G1 / 2 "with special sealing ring for reliable and fast installation.

- Material: brass
- Finish: chrome
- Cover: ABS plastic, chrome
- Control: 6 mm hex key

ATTENTION!
When ordering the set, it is necessary to order a compression fitting (not included).

The non-return valve is hidden under the decorative cover. It is closed with a hexagonal key. It does not serve to regulate the temperature, only to close the pipes, eg in the case of dismantling the radiator, without the need to drain the heating medium.

Central heating

In the case of central heating, the selection of the connection valves is very important. You can choose between using a manual valve or a valve with a thermostatic head.

Manual valve: the valve control head can be installed on the left/right side regardless of the hot water supply location. The temperatur eis controlled manually.
A valve with a thermostatic head: the integrated thermostat maintains the temperature inside the towel rail. The thermostatic head must be located at the hot water inlet (except MONO ONE).

The connection valves we offer are supplied with a clamping fitting for the most common pipes (O15 mm for copper and O16 mm for Alupex), so there is no need to buy anything else for the connection. For covering the inlet pipes and holes in the wall, we recommend the addition of cover rosettes.

Towel rail with a 50 mm connection spacing

Towel rail with side connection

Towel rail with a single-point connection